![]() ![]() Release the feed button after the red light flashes twice, wait for the calibration process to complete and press the feed button once.įor further help with your printer email or call 01536 414222. Signal to begin calibration after turning on the printer with the feed button held down.Power-up has failed, switch the power off and then on again.When installing the ribbon spools into the printer make sure the notches in the spools fit snugly into the corresponding keys that are on the left side ribbon spool holders. The ribbon spool is slipping on the ribbon spool holder on TLP models: The cardboard spools that the ribbons are wound onto should have two notches cut out on the left side.The printer is out of labels or ribbons (TLP models only).Check to make sure the printer is not out of labels or out of ribbon if it is a TLP model. This indicates the printer is in an error state and will not print until the error is cleared. Please check your program or labelling software and resend the print job. The printer has a syntax or command error.Press down firmly on both sides of the top cover of the printer to see if the error light clears and goes to green. The print head is open, not locked down all the way.This indicates that the printer is free from errors and is ready to print, is printing or is paused. If this does not fix the problem please call our technical support team for further help. Check the power connection from the power supply to the printer and check that the power is switched on at the back of the printer and at the plug socket. This means that the printer has no power. Push the lid closed until both yellow latches snap shut.The status light on your Zebra desktop printer is located around the edge of the feed button and indicates the health of the printer.įor printer models: Orion (2442, 24), LP/TLP Strata (2684), LP/TLP2722, 2742, 3742, LP/TLP2824, LP/TLP 2844 and TLP3842.Flip the labels up and align the movable sensor to the center position.Pull the labels out past the cutter at the front of the printer.Make sure the label roll is secure and turning freely. Release the roll guides and push them together.Zebra GK420D Status Lights GK-Series Printer Status Light Details - Applies To Zebra GK420d The status. Pull the yellow roll guides apart and insert the label roll with the labels facing upwards. To Zebra Keeps Zt410 Switching Transfer Thermal. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |